Photo montage

How to make a photo pendant

How do you put a picture on a pendant?

How to Fit a Photograph into a Locket

  1. Remove the Plastic Insert. Many lockets will have a plastic insert where the photo is supposed to go. …
  2. Choose and Prepare the Photo. The plastic insert is perfect for choosing the photo and outlining it to the exact size. …
  3. Put the Picture into the Locket. …
  4. Replace the Insert.

How big is a locket photo?

If you are unable to measure your locket’s image space, you can estimate it. A general estimate is about 1 millimetre (0.10 cm) or so smaller than the size of your locket. It is better to guess high than aim low, because you can always trim the edges of your image later.

Can I put a picture in resin?

Using a foam brush, coat your photo, picture side up, with 2-3 coats of Mod Podge. It is important to make sure photo is well sealed with Mod Podge as the resin will stain your photo if it comes in direct contact with the paper. Allow 15 to 20 minutes drying time for each coat.

How do you put on a pendant?

Instructions for Attaching a Pendant to a Necklace

  1. Jump Ring. Using jump rings is the simplest way to attach a pendant. …
  2. Head Pin or Eye Pin. Insert a head pin or eye pin through the hole of the bead or component. …
  3. Bail. Choose a suitable wire for the bead or component which you want to make into a pendant. …
  4. Pinch Bail.

Leave a Reply

Your email address will not be published. Required fields are marked *